Home Products & Services

Why No One Talks About Garages Anymore

How To Install a Garage Door the old door of the garage should be first removed using the instructions in the manufacturer’s manual, this is undertaken by unlatching the door from its pulley system, before unscrewing the tracks, the door panels are set apart, one panel is removed at a time so that it does not fall on someone The areas where the door is supposed to be installed are then measured, these are; the door-opening height and width, the headroom from the top of opening to ceiling, and the back room which is the length of the garage, having done the proper measurements, the stops temporarily attach to both sides of the opening, making sure they are flush with the inside edge of the door jamb, the bottom piece of the new door is laid out using the sawhorses, if necessary any required weather stripping is attached, any hinges that are necessary are additionally attached and handles lifted to piece Next, using a level in order to set the piece properly, the bottom piece is inserted into the frame of the door, after the piece is set in place, the tap nails partway into each jamb, the nails are bent slightly or slant so that they are secure in place, then using the manufacturer’s instruction, the vertical, curved and horizontal pieces of the track are assembled and then set aside The second panel is then installed on top of the first one, nails are then hammered into the side jambs so that they are well held in place, hinges are the next installed, then the process is repeated according to the number of panels that are necessary, however, it is a requirement that each of the pieces is anchored into the door jamb, this marks the completion of the fourth step undertaken when installing a garage door
Lessons Learned About Services
After all the sections are secured, the rollers are then installed in the section that supports the rollers, when that is done, the rollers are then placed in the previously assembled track, the brackets of the tracks are secured as one goes along, however, caution should be taken not to press the rollers exceedingly tight against the track, this is to avoid friction because it can cause damage to the door which will end up destroying the door eventually during usage
What No One Knows About Repairs
when the vertical tracks are well secured against the jambs, installation of the curved and horizontal pieces takes place, the previous measurements are used when installing the horizontal pieces, the tracks should be levelled in order to make sure they are straight and they should point 90 degrees away from the opening, according to the manufacturer’s instructions springs are then assembled, when attaching the springs to the pulley, the door is lifted to half length and then pulled up the remaining distance, that is basically how to install a garage door